RUBBERALL® PEEL & STICK PIPE BOOT DATA SHEET

DESCRIPTION:

Multi-Diameter Peel & Stick Pipe Boot are specifically designed to be used in roofing applications for flashing of round penetrations. Peel & Stick Pipe Boot will fit various penetrations and must be cut to correct pipe diameter before installation. Each box of pipe flash contains universal clamps.

APPLICATION:

Penetration must be clean of prior flashing and foreign materials. Cut along the top edge of the ring on the corresponding ring to the size of the pipe. The pipe boot should fit snugly over the pipe. Install the pipe boot over the pipe and turn the boot inside out, exposing the bottom of the pipe flange. Apply Seam Tape Primer at least 10" in all directions from the pipe with a Scrub Pad and allow to dry. Remove the release paper from the Peel & Stick Pipe Boot, pull down and adhere to the field membrane. Roll adhesive area with a steel roller. Install Lap Caulk, Water Cut-Off Mastic and clamp ring per RUBBERALL® installation guide.

TYPICAL PHYSICAL PROPERTIES:

PIPE BOOT:

Material:

Molded EPDM

Color:

Black

Sizes:

Universal — Fits 1" O.D. to 6.875" O.D.

Clamp:

Stainless Steel — worm gear type (included)

Pipe Flange:

13" outside diameter

Thickness:

0.055" — 0.075"

TAPE BACKING:

Base:

Rubber Polymer

Color:

Black

Solvents:

None

Percent Solids:

100%

Cured State:

Cured

Thickness:

.030" + .005"

Home About RUBBERALL Roofing Products Water Garden Products Contact Us About BRITE-N-EZ BRITE-N-EZ Roofing Products Roof Coatings Site Map