Water Tight Technologies

  RUBBERALL® Family of Products
  RUBBERALL® Membrane Qualities
 
   
      RUBBERALL® Membrane
      Uncured Flashing Patch
      Cured Cover Strip
   
      Solvent Based Adhesive
      Water Based Adhesive
      Rubber to Rubber Adhesive
      Water Cut-Off Mastic
      Lap Caulk
   
      Seam Tape
      Tape Primer-Plus
      Membrane Cleaner
      Screws & Plates
      Pipe Boot
      Termination Bars
  MSDS Sheets
  Warranty
  Installation Manual
  Installation Video Guide
 
see Printer-Friendly Version 

RUBBERALL® TERMINATION BAR DATA SHEET

DESCRIPTION:

Termination BarRUBBERALL® Termination Bar is intended for attaching and sealing flashing termination as outlined in the RUBBERALL® Installation Manual.

APPLICATION:

Substrates must be free from dust, dirt, oil, water and other contaminants. Wall areas above Termination Bar must be waterproof. Apply RUBBERALL® Water Cut-Off Mastic between the substrate and flashing directly under where the Termination Bar is to be installed. Anchor bar through each pre-punched hole. Remove excess flashing material above termination bar.

TYPICAL PHYSICAL PROPERTIES:

Material:

6063 — T6 Aluminum

Length:

10 ft., 5.ft

Height:

1.0 in. +/- .012"

Thickness:

.187 in.

Holes:

.25 in. on 6 in. center

STORAGE:

Store in unopened original containers protected from the weather.

 
 
Home About RUBBERALL Roofing Products Water Garden Products Contact Us About BRITE-N-EZ BRITE-N-EZ Roofing Products Roof Coatings Site Map