see Printer-Friendly Version

RUBBERALL® PEEL & STICK PIPE BOOT DATA SHEET

DESCRIPTION:

Multi-Diameter Peel & Stick Pipe Boot are specifically designed to be used in roofing applications for flashing of round penetrations. Peel & Stick Pipe Boot will fit various penetrations and must be cut to correct pipe diameter before installation. Each box of pipe flash contains universal clamps.

APPLICATION:

Penetration must be clean of prior flashing and foreign materials. Cut along the top edge of the ring on the corresponding ring to the size of the pipe. The pipe boot should fit snugly over the pipe. Install the pipe boot over the pipe and turn the boot inside out, exposing the bottom of the pipe flange. Apply Seam Tape Primer at least 10" in all directions from the pipe with a Scrub Pad and allow to dry. Remove the release paper from the Peel & Stick Pipe Boot, pull down and adhere to the field membrane. Roll adhesive area with a steel roller. Install Lap Caulk, Water Cut-Off Mastic and clamp ring per RUBBERALL® installation guide.

TYPICAL PHYSICAL PROPERTIES:

PIPE BOOT:

TAPE BACKING: