MATERIAL SAFETY DATA SHEET

SECTION 1 - PRODUCT IDENTIFICATION

Product Name:
Bonding Adhesive – Water Based (contact)

24-Hour Emergency Telephone Number:
800-424-9300 CHEMTREC

Chemical Name/Synonyms:
Propylene Glycol Based Adhesive

Manufacturer's Name:
Water Tight Technologies, LLC

Chemical Family:
Propylene

Manufacturer's Address:
P.O. Box 899 Payson, AZ  85547

Chemical Formula:
Not Established

NFPA Acute Hazard Rating: 
NA
HMIS Acute Hazard Rating:
Health 1, Flammability 0, Reactivity 0

SECTION 2 - CHEMICAL COMPOSITION

Hazardous Components (chemical names)

OSHA (1910. 1200)         

Case No.

OSHA STEL

OSHA PEL

ACGIH TLV

Propylene Glycol   (less than 1% of total formula)

25265-71-8

57-55-6

Skin-skin absorption must be considered as a route of exposure

C-ceiling + allow. exposure level should not be exceeded for any time period

Stel=short term exposure limit (X-SARA 313 = Chemical is subject to reporting requirements of Section 313 of Title 111 of S.A.R.A 40 CFR Part 372)

SECTION 3 - PHYSICAL & CHEMICAL CHARACTERISTICS

Appearance/Odor:
White milky liquid

Physical State:
Liquid

Solubility in Water:
Insoluble

Boiling Point:
212˚F (100˚C) water

Specific Gravity (H₂O=1):
1.0

Melting Point:
N/A

Vapor Pressure:
Not Established

Vapor Density (Air=1):
Heavier than air

Freezing Point:
Not Established

Percent Volatiles:
50%

Evaporation Rate:
Slower than diethyl ether

Reactivity in Water:
N/A

pH (Full Strength):
N/A

pH (Recommended Dilution):
N/A

Refraction Index:
N/A

SECTION 4 - FIRE & EXPLOSION HAZARD DATA

Flash Point:
N/A

Flammable Limits (in air):
N/A

Extinguishing Media:
Water

Fire Fighting Procedures:
None Known

Hazardous Decomposition Products:
Burning, including when heated by welding or cutting will produce smoke, Carbon Dioxide, Carbon Monoxide.

Special Fire & Explosion Hazards:
Not Established

Method Used:
Not Established

Auto-Ignition Temperature:
Not Established

SECTION 5 - HEALTH HAZARD DATA

Permissible Exposure Limit:
313 mm hg @ 20° C

Signs and Symptoms of Exposure:
May cause respiratory irritation

Effects of Overexposure:
Medical Conditions Aggravated by Exposure:
May cause transient skin irritation / eye irritation

Acute:
May cause severe gastrointestinal irritation if swallowed

Chemical Listed as a Carcinogen (or Potential Carcinogen):
None currently known.

Chronic:
None currently known.

Emergency & First Aid Procedures:
Eye Contact: 
Flush with large amounts of water, lifting upper and lower lids occasionally. Continue for at least 15 minutes  and call physician.
Skin Contact:
Remove contaminated clothing and wash affected area with soap and water. Obtain medical attention if irritation persists.
Inhalation:
Remove to fresh air. Administer oxygen or artificial respiration, if necessary. Call physician.
Ingestion:
If swallowed, immediately give 1 or 2 glasses of water and call a Poison Control Center, Hospital Emergency Room, or Physician for information to induce vomiting.
Primary Route of Entry:
Inhalation, skin or eye contact.

SECTION 6 - REACTIVITY DATA

Stability:
Stable at ambient temperatures and pressures

Incompatibility:
None known

Hazardous Decomposition Products:
Smoke, carbon monoxide, and carbon dioxide.

Hazardous Polymerization:
Will not occur.

Conditions to Avoid:
None known

SECTION 7 - SPILL OR LEAK PROCEDURES

Steps to be taken in case material is released or spilled:

Small spill:
Absorb using inert material. Transfer into secure containers for proper disposal.
Use personal protective equipment as outlined below.

Large Spill:
Same as small spill.

WasteDisposal Method:
Dispose in accordance with federal, state, and local regulations.

SECTION 8 - SPECIAL PROTECTION

Respiratory Protection:
If applied by spraying, use NIOSH-Certified respiratory protection for organic vapor if necessary. Refer to OSHA 29 CFR 1910.134 “Respiratory Protection”.

Eye Protection:
Wear safety glasses with side shields, Wear Face shield as necessary when spraying.

Protective Gloves:
Impervious gloves are recommended to prevent skin contact.

Other Protective Equipment:
Under normal application conditions, protective glasses, gloves, and clothing are adequate.

Ventilation:
Natural ventilation should be adequate under normal conditions.

SECTION 9 - SPECIAL PRECAUTIONS OR OTHER COMMENTS

Storage/Handling:
Store in cool, dry, well ventilated facility. Keep containers closed when not in use. Protect from freezing.

Other Precautions:
Provide adequate ventilation and avoid prolonged or repeated contact with the skin. Wash with soap and water after contact. Do not take internally. Close containers after each use. Keep away from children.

Work/Hygienic Practices:
Maintain good personal hygiene practices. Wash contaminated clothing before reuse. Do not eat, drink, or smoke in work areas. Wash exposed skin before eating, drinking, smoking, or applying cosmetics.

SECTION 10 - TRANSPORTATION

Regulatory Agency:
Not Applicable

Identification Number:
Not Applicable

Proper Shipping Name:
Not Applicable

Labels Required:
Not Applicable

Hazard Classification:
Not Applicable

Other Requirements:
Not Applicable

SECTION 11 – MISCELLANEOUS INFORMATION

Additional Comments:
None.

Date of Previous MSDS:
August 2000

Changes Since Previous MSDS:
Comment change in sections:  1 thru 9
Add sections: 10,11

Telephone Number for Additional Information:
(574) 293-9096

DISCLAIMER

The information contained herein is based on data considered accurate which has been obtained from other companies and organizations. However, no warranty or representation is expressed or implied that the information is accurate, complete, or representative. Water Tight Technologies, LLC. assumes no responsibility for injury to the buyer, the buyer’s employees, or any third persons if reasonable safety procedures are not followed.