Terminating RUBBERALL® On Fascia

Bring RUBBERALL® membrane over edge of roof approximately 4". Where membrane wraps an inside or out side corner, create a flap and tack to one side of the fascia with a roofing nail. Using RUBBERALL® Termination Bar in either 5' or 10' lengths and an appropriate length RUBBERALL® Screw, secure the Termination Bar with a screw in every hole. Leave a 1/4" gap between Termination Bars for expansion.

Termination Bar can easily be bent around on outside corner. With a utility knife cut excess membrane from the bottom side of the Termination Bar. Apply a bead of Lap Caulk to the top of the Termination Bar. It is also advisable to put a spot of Lap Caulk over each screw to prevent water from penetrating around screw and rotting fascia.

Figure 27