
		RUBBERALL® Family of Products
		RUBBERALL® Membrane Qualities
		Product Specifications & MSDS Sheets
		Warranty
		Installation Manual
			General Information
			RUBBERALL® User Cautions And Warnings!
			RUBBERALL®Tools Needed
			RUBBERALL® Products Available
			Roof Surface Preparation
			Laying Out RUBBERALL® EPDM Membrane
			Pipe Penetrations
			Protrusion In The Roof
			Adhering Membrane With Solvent Based Bonding Adhesive
			Adhering Membrane With Water Based Bonding Adhesive
			Seaming Membrane Panels With Seam Tape
			Splicing And Seaming With Rubber To Rubber Adhesive
			Alternative Panel Layout And Seaming
			Perimeter Walls & Inside Corners
			Outside Corner Finish Detail
			Cover Strip
			Peel And Stick Pipe Boot
			Pipe Or Conduit Flashings Using Uncured Flashing With Tape
			Wall Termination
			T-Joints
			Field Seam Radical Bend
			Roof Edge Termination With Metal Drip Edge
			Terminating RUBBERALL® On Fascia
			RUBBERALL® Membrane To Shingle Transition
			One Piece Drain Sleeve
			Drains With Clamping Rings
			Pitch Pockets
			Protecting RUBBERALL® Membrane In High Foot Traffic Areas (Decks)
			Repair Of RUBBERALL® Membrane
			Application Review
			Frequently Asked Questions
			Glossary
			RUBBERALL® Roofing Membrane Material And Labor Limited Warranty
			Warranty Registration
		Installation Video Guide

see printer-friendly version

Repair Of RUBBERALL® Membrane

If your RUBBERALL® membrane is punctured, repairs can be made easily by:

1. Clean membrane with Membrane Cleaner

2. Prime area with Seam Tape Primer Plus using RUBBERALL® Scrub Pad at least four inches (4") in all directions from puncture.

3. After the primer has flashed off, cut a piece of Cured Cover Strip with Tape 3" larger than the puncture and round corners. Remove backing and place over puncture.

4. Roll with hand roller.